Arduino Reflow Oven Controller: Temperature, PID and Process States

Arduino Reflow Oven Controller: Temperature, PID and Process States — photograph from the project archive.

This reflow-controller archive contains the main temperature-control sketch, bench photographs, controller datasheets and three published demonstrations. It documents an Arduino-based control experiment using a thermocouple interface and a separate power controller.

How the project works

The main sketch reads a MAX31855 thermocouple interface and advances through idle, preheat, soak, reflow, cool and completion states, with additional too-hot and error states. The stored profile uses a 150–200 °C soak region, a 250 °C reflow maximum and a 100 °C cooling threshold.

PID settings change between process stages. Sensor sampling is set to one second, and serial output reports elapsed time, setpoint, measured temperature and process state. The saved output path scales the controller value into a PWM output; the photographs and MCPC1225A documentation explain the associated bench power-control hardware.

Hardware and configuration

ItemIn the supplied code
Thermocouple interfaceMAX31855: SO A3, CS A2, CLK A1
Control outputD5 PWM
Start switch inputA0
Serial monitor57600 baud

Working with the supplied code

Treat the temperatures and PID coefficients as the original experiment’s parameters. A usable reflow process needs a profile matched to the solder paste, board and oven, with temperature measurements that confirm the actual response.

The separate ArduinoI2CMaster and ArduinoI2CSlave sketches are small network examples, not proof that a complete touchscreen/master controller is integrated. The main source still lists that work as a to-do. Mains switching and heater protection require a correctly engineered enclosure, isolation and independent thermal protection; the bench photos are documentation, not a finished oven wiring guide.

Arduino Reflow Oven Controller: Temperature, PID and Process States — photograph from the project archive.
Arduino Reflow Oven Controller: Temperature, PID and Process States — photograph from the project archive.

Video demonstrations

Arduino Reflow Oven Controller 01 — Ovidiu Carstea on YouTube
Arduino Reflow Oven Controller 02 — Ovidiu Carstea on YouTube
Arduino Reflow Oven Controller 03 — Ovidiu Carstea on YouTube

Source code and project files

Browse this project on GitHub. The files below are useful starting points for the sketches and references discussed in this post.

Download the used libraries (ZIP, 14.7 MB).

Ovidiu Carstea’s controller source credits Lim Phang Moh / Rocket Scream and Brett Beauregard’s PID library. The I2C templates are by Hazim Bitar.

These notes describe the archived source and project media. The sketches have not been rebuilt or tested on hardware for this article.

Scroll to Top